Custom Engeneering s'print Manuel d'utilisateur télécharger pdf (Page 18)

1. INSTALLATION AND USE

71-

DPT100-B

* SETUP DEFAULT *

HEAD TEMP. [°C] = 22.5

BATT TEMP. [°C] = 25.0

HEAD VOLT [V] = 6.3

Interface :Infrared

Baud Rate : 9600 bps

Data length : 8 bits/chr

Parity : None

Handshaking : Xon/Xoff

Autofeed : CR disabled

Battery : 1600 mAh

Standby : 5 MIN

Print Density : 0

[PUSH] ENTER SET-UP

[FAST PUSH] EXIT SET-UP

The printer’s configurable parameters are:

• Interface: RS232

, Infrared

(7)

• Baud Rate: 38400, 19200, 9600

, 4800, 2400, 1200, 600.

• Data length: 7, 8

bits/car.

• Parity: None

, even or odd.

• Handshaking: XON/XOFF

or Hardware

(8)

• Autofeed: CR deactivated

or CR activated.

• Battery: 600 mAh, 800 mAh, 1000 mAh, 1200 mAh

, 1400 mAh,

1600 mAh, Alkaline

(9)

• Standby: 30 sec, 1min, 2 min, 5min

, 10 min, 20 min

(10)

• Print density: -2, -1, 0

, +1, +2.

Please note: the parameters marked with the symbol

represent the default

values.

(7)

Note

If the Interface parameter is set in infrared and flow control is required, any time a

transmission is effected a time break of one time and a half the byte transmission

is needed (for example 1.5 msec at 9600 bps). The reason is for Half Duplex type

of infrared line communication. As a result the Busy condition check must be waited

when transmitting data to the printer.

If said condition would slow down print-out, it is alternatively possible to transmit the

bytes to be printed in fixed length blocks (for example 16 bytes at a time) and to

wait for the necessary time to receive a likely XON/XOFF.

(Fig.1.9)

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 50 51

Commentaires sur ces manuels

Pas de commentaire

Custom Engeneering s'print Manuel d'utilisateur Page 18

Commentaires sur ces manuels

Produits connexes et manuels pour Imprimer et scanner Custom Engeneering s'print